Important: Use custom search function to get better results from our thousands of pages

Use " " for compulsory search eg:"electronics seminar" , use -" " for filter something eg: "electronics seminar" -"/tag/" (used for exclude results from tag pages)


Tags: Circuits, Comparator, Subtractor, Adder, Applications, OP AMP Applications Adder Subtractor Comparator Circuits,
 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
OP AMP Applications – Adder, Subtractor, Comparator Circuits
Post: #1

OP AMP Applications – Adder, Subtractor, Comparator Circuits

AIM:

To design adder, subtractor and comparator for the given signals by using operational amplifier.

THEORY:
Adder:


A two input summing amplifier may be constructed using the inverting mode. The adder can be obtained by using either non-inverting mode or differential amplifier. Here the inverting mode is used. So the inputs are applied through resistors to the inverting terminal and non-inverting terminal is grounded. This is called “virtual ground”, i.e. the voltage at that terminal is zero. The gain of this summing amplifier is 1, any scale factor can be used for the inputs by selecting proper external resistors.

Subtractor:

A basic differential amplifier can be used as a subtractor as shown in the circuit diagram. In this circuit, input signals can be scaled to the desired values by selecting appropriate values for the resistors. When this is done, the circuit is referred to as scaling amplifier. However in this circuit all external resistors are equal in value. So the gain of amplifier is equal to one. The output voltage Vo is equal to the voltage applied to the non-inverting terminal minus the voltage applied to the inverting terminal; hence the circuit is called a subtractor.

Comparator:

The circuit diagram shows an op-amp used as a comparator. A fixed reference voltage Vref is applied to the (-) input, and the other time – varying signal voltage Vin is applied to the (+) input; Because of this arrangement, the circuit is called the non-inverting comparator. Depending upon the levels of Vin and Vref, the circuit produces output. In short, the comparator is a type of analog-to-digital converter. At any given time the output waveform shows whether Vin is greater or less than Vref. The comparator is sometimes also called a voltage-level detector because, for a desired value of Vref, the voltage level of the input Vin can be detected.

PROCEDURES:

Adder:

1. Connect the circuit as per the diagram shown in Fig.8.1.
2. Apply the supply voltages of +15V to pin7 and pin4 of IC741 respectively.
3. Apply the inputs V1 and V2 as shown in Fig. 8.1.
4. Apply two different signals (DC/AC ) to the inputs
5. Vary the input voltages and note down the corresponding output at pin 6 of the IC 741 adder circuit.
6. Notice that the output is equal to the sum of the two inputs.
B) Subtractor:
1. Connect the circuit as per the diagram shown in Fig.8.2.
2. Apply the supply voltages of +15V to pin7 and pin4 of IC741 respectively.
3 Apply the inputs V1 and V2 as shown in Fig.8.2.
4. Apply two different signals (DC/AC ) to the inputs
5. Vary the input voltages and note down the corresponding output at pin 6 of the IC 741 subtractor circuit.
6. Notice that the output is equal to the difference of the two inputs.
 

Marked Categories : adder and comparater, reference of op amp using adder and subtractor, operation amplifier as adder and subtractor, op amp as comparator adder, theory of design implemention of adder subtractor using op amp s, theory of design and implementation of adder subtractor using opamp, design and implementation of adder and subtractor using op amp theory, to design and construct subtractor circuit of op amp, adder circuit of op amp, design on adder cut using op amp omegawebs gmail com, subtractor circuit using op amp, 741 voltage adder and subtractor, design of adder subtractor circuit using op amp with 3 inputs, op amp applications adder subtractor comparator,

[-]
Quick Reply
Message
Type your reply to this message here.

Image Verification
Image Verification
(case insensitive)
Please enter the text within the image on the left in to the text box below. This process is used to prevent automated posts.

Possibly Related Threads...
Thread: Author Replies: Views: Last Post
  verilog implementation of carry bypass adder Guest 0 0 09-04-2017 08:24 PM
Last Post: Guest
  electrical circuits by nagoor kani pdf Guest 1 148 08-04-2017 11:14 AM
Last Post: jaseela123
  solution manual for roy choudhary s linear integrated circuits 4th edition pdf Guest 0 0 02-04-2017 11:22 AM
Last Post: Guest
  applications of iboc technology Guest 1 0 22-03-2017 03:31 PM
Last Post: jaseela123
  seminar report on gsm based home applications control in pdf format Guest 1 0 07-03-2017 09:26 AM
Last Post: jaseela123
  sigma comparator animation Guest 2 2,850 02-03-2017 11:19 AM
Last Post: jaseela123
  electrical comparator ppt presentation Guest 1 0 01-03-2017 11:20 AM
Last Post: jaseela123
  electrical comparator ppt for download Guest 1 0 01-03-2017 11:20 AM
Last Post: jaseela123
  biomedical applications of 555 timer Guest 3 116 01-03-2017 11:17 AM
Last Post: jaseela123
  applications of matrices in engineering field in a powerpoint presentation Guest 2 571 01-03-2017 09:27 AM
Last Post: jaseela123
This Page May Contain What is OP AMP Applications – Adder, Subtractor, Comparator Circuits And Latest Information/News About OP AMP Applications – Adder, Subtractor, Comparator Circuits,If Not ...Use Search to get more info about OP AMP Applications – Adder, Subtractor, Comparator Circuits Or Ask Here

Options: